Tel：400-900-9069

Product Specifications

Product name: High-power side lighting straight light

Series Model: DGW450E   DGW451E    DGW452E

Product use: Applicable occasions: single-sided light boxes in shopping malls, airports, subways, bus stops, etc.

Applicable occasions: Indoor and outdoor

Scope of application: can be applied to 10-25cm thickness light box

Product Features:

1. Using American CREE/3535 high-power LED light source, the luminous efficiency of the product is as high as 100lm/W;

2. Special lens design, high illuminance uniformity on the surface of the light box;

3. Using constant current drive technology, aluminum substrate has good heat dissipation effect, energy saving and environmental protection;

4. The product warranty is 3 years;

Installation:

Permanently fixed with screws;

Photoelectric parameters:

Remark:

①The test environment temperature is 25±2℃;

②The above data are typical values, and the actual parameters of the product may be different from the typical data. Data are subject to change without notice.

③This module is a high-power product and cannot use double-ended power supply.

Dimensional drawing (unit: mm [in]):

Connection diagram:

Light distribution graph:

Installation Instructions:

1. Use 2x2.5mm2 or more cables for the main power cord. If the power cord of the product needs to be lengthened, you must choose a wire with a specification of 0.75mm2/18# or above, so as to avoid overloading the power cord and cause excessive heat and cause adverse consequences. The length of the power cord should not exceed 3 meters, otherwise the line loss will increase and the total power will increase;

2. Please use the wiring scheme in the connection diagram, and the power output multiple channels should be connected to multiple channels to prevent the power overload of a single power supply channel;

3. When installing the product, screw the screw into the hole of the fixing frame, lock it, or install it with adhesive backing;

4. When the wire conductor is exposed at the end of the product, first cut off the exposed wire with diagonal pliers, and use a crimping cap to press the end to death for insulation protection;

5. In order to ensure waterproof and anti-corrosion, after the power cord is screwed into the terminal, it is recommended to inject one-component silica gel (or neutral glass glue, or waterproof grease) into the terminal to cover the exposed copper wire of the power cord for protection;

6. When installing the power supply of this product, please do not touch or work with electricity;

7. It is recommended to use a switching power supply (with short-circuit protection, overload protection) that has passed the relevant safety certification.

Installation diagram description

The test panel is a 3mm thick acrylic whiteboard with a light transmittance of about 60%

The metal light box model was selected for the experiment

Evenly arranged according to product photoelectric performance parameters

package instruction

※Packed in electrostatic bag Size: 250*350mm

※Outer box size: 457*337*320mm

※10PCS/layer, 10 layers per box total 100PCS

※Net weight (NW) 6.5(1±10%)kg

※Gross weight (GW): 8.7(1±10%)kg

Remarks: The above packaging quantity and weight are only for the packaging method shown in the figure. When other packaging methods are used, the packaging quantity and weight will be different, and the actual product shall prevail.