The installation of light boxes is a meticulous task. The editor has compiled some methods and characteristics of light box installation for your study and reference, which can greatly improve the installation speed and quality. The light box needs to be installed by an electrician. The installation steps are as follows:

1. Determine the installation location of the light box, and determine the installation method according to the actual situation and the type of light box;

2. Measure the size: Determine the fixed point for installing the light box according to the actual size of the mounting hole on the back of the light box. There are three cases:

A. For walls made of aluminum-plastic panels, wood panels, iron panels, etc., they can be directly fixed with screws;

B. For general cement walls or brick walls, first punch holes with impact drills, and then fix them with expansion screws

C. For the surface of the wall is ceramic tile, marble, glass, etc., you can first drill through the surface with a glass drill, then drill the expansion screw holes, and then fix the light box.

3. For the light box that needs to be hoisted or hung, after selecting the installation position, determine the fixed point for installing the light box according to the actual size of the installation hole of the light box, and then install the hanger and connect the ground wire.

4. Wiring: The outlet end of the power cord of the light box is on the back. If the power supply of the light box is on the back of the light box, you can cut off the plug of the power cord, wire it directly, and fasten the power connector with a special insulating sleeve; In addition to the installation position of the light box, the light box can be changed

The outlet line of the power supply is at the edge of the light box, and then insert the three-phase plug into the corresponding power socket;

5. Fix the light box: Open the top cover of the light box and install it at the fixed point (that is, use an electric drill to drill a hole at the position of the power cord at the base of the light box, re-install the power cord, and adjust it to a horizontal state with a spirit level);

6. Power on and test the light, and clean the surface of the light box.