Tel：400-900-9069

After all the LED injection modules are installed, you can use 0.75mm or 18AWG wires to connect to the power supply. The distance between the power supply and the module should be within 5 meters. If the font size is large, the power supply can be built in without affecting the heat dissipation of the module. LED injection module power supply installation precautions: 1. The special switching power supply for LED injection molding module should pay attention to waterproof measures. 2. Switch electricity

The editor has collected some LED injection molding module installation skills, and shared them with you here for communication and learning. 1. At this stage, the light sources used for luminous characters are mainly LED injection molding modules with a conventional input voltage of DC12V. The three-lamp, two-lamp, and one-lamp light source modules are relatively common. The DC12V output by a constant-voltage switching power supply is power supply, so pay attention to the installation of LED injection molding

The detailed characteristics and authenticity (false) of the CREE lamp beads of the LED injection moulding module Q: Does Cree produce CREE lamp beads chips for red LED injection molding modules? A: Cree has never produced CREE lamp bead chips for red LED injection moulding modules, only blue light, green light and ultraviolet LED injection moulding module CREE lamp bead chips.

The LED injection molding module lamp beads EMC3030 is Yuanlei's innovative high-power LED products. Its principle is the same as the EMC3014, and they are all lamp beads made of new material EMC. The characteristics of LED injection molding module lamp beads EMC3030 are high temperature resistance, long life, high UV resistance, The specific parameters of the lamp beads EMC3030 of the LED injection module are as follows: Drive current: 150mA; drive

MOX268ELED injection molding module is one of the LED modules. Compared with other types of modules, the light-emitting angle is large, the brightness is high, and the light decay is low, so it is more widely used. Applicable occasions: single-sided light boxes in shopping malls, airports, subways, bus stations and other places; Scope of application: suitable for single-sided light boxes with a thickness of 10-20cm. Product Features of MOX268ELED Injection Molding Module