Tel：400-900-9069

After all the LED injection modules are installed, you can use 0.75mm or 18AWG wires to connect to the power supply. The distance between the power supply and the module should be within 5 meters. If the font size is large, the power supply can be built in without affecting the heat dissipation of the module. LED injection module power supply installation precautions: 1. The special switching power supply for LED injection molding module should pay attention to waterproof measures. 2. Switch electricity

The editor has collected some LED injection molding module installation skills, and shared them with you here for communication and learning. 1. At this stage, the light sources used for luminous characters are mainly LED injection molding modules with a conventional input voltage of DC12V. The three-lamp, two-lamp, and one-lamp light source modules are relatively common. The DC12V output by a constant-voltage switching power supply is power supply, so pay attention to the installation of LED injection molding

Nowadays, LED injection molding modules are widely used, mainly in the following three points 1. Advertising signs, lighting signs, (ultra-thin) light boxes, three-dimensional luminous characters, blister characters, other advertising lighting, etc.; 2. Hotel, KTV, shopping malls, entertainment city interior (dark slot), exterior wall lighting, landscape layout, stage decoration, urban lighting, etc. 3. Home shoe cabinets, wardrobes, hidden ceilings, showrooms

Introduction to the manufacturing process steps of LED injection molding module 1. Microscopic inspection of LED injection molding module chips: whether there is mechanical damage and pitting on the surface of the material, whether the chip size and electrode size meet the process requirements and whether the electrode pattern is complete. 2. LED injection molding module expansion, because the LED injection molding module chips are still closely arranged after dicing and the spacing is very small (about 0.1mm), which is not conducive to the subsequent process.

The research on ABS engineering plastics, raw materials for LED injection molding modules, began in the 1960s and has developed rapidly in recent years. According to statistics, the total consumption of plastic alloys (including modified resins) in my country is about 1.2 million to 1.4 million tons, while the domestic supply is less than 600,000 tons, and the annual import volume is as high as 900,000 tons; and my country's LED injection molding module raw materials ABS engineering plastics (mainly blended resins and modified