With the rapid development of business, the use of LED lens modules is also increasing, and most buyers are not professional installers. They often encounter many problems when installing LED modules. The manufacturer's technicians ask for help, so what should we pay attention to when we go to install it.

1. When we install the LED lens module, we must remember to use special glue for woodworking or double-sided glue. Only these two glues can make the card slot of the module and the blister bottom plate very firmly pasted together. Of course, there is one thing to keep in mind when using it, that is, glass glue must be used, otherwise it is impossible to support the long-term outdoor exposure with double-sided tape alone.

2. When installing the LED module, it must be a low-voltage input. Do not directly connect the 220V power supply to the LED. If you connect it directly, it will cause the overall burn of the LED module.

3. After installation, the switching power supply we want to use must have been adjusted according to the typical characteristics of the LED lens module, and you cannot freely rotate and link the LED module in the subsequent use process. Adjust voltage button.

Fourth, the LED modules that can be purchased also have their own positive and negative poles, so when installing, you must pay attention to the wiring ports of the power supply, so that the positive and negative poles of the two are corresponding. If the positive and negative poles are reversed when you install, then even if the LED module is installed, it will not emit light.

5. As mentioned above, when connecting the voltage to the LED module, it must be connected to low voltage. In addition to this requirement, we must also ensure that the power supply is installed within 10 meters around the LED light-emitting module.

6. When installing the LED module, do not squeeze or push any device on it, because the LED is a very delicate device, and your large squeeze, push, and pressure will cause damage to the device.

7. Those who have had installation experience should know that there are some barb designs on the wire seat. This design is to prevent the connecting wire from falling off easily from the wire seat, but if we are installing the LED lens It is not very convenient to insert the socket when the module is installed, so we need to exit and then reinsert it. In any case, ensure that the wiring of the LED module is firm to avoid the phenomenon of falling off later.

8. We use LEDs to make the content clearly visible, so we must pay attention to their spacing during installation, and avoid overlapping of light and shadow. It is best to control the number of points per square meter between 100 groups.

If you need to install the LED lens module, you may wish to take a look at this article, I believe it will help you, and you can avoid mistakes after understanding.